AFR Shows Current Table But Does Not Pull In Correct Rate

|AFR Shows Current Table But Does Not Pull In Correct Rate

AFR Shows Current Table But Does Not Pull In Correct Rate

When I click on the AFR Table, it shows the current table. However, when I am on a screen that uses the AFR, it does not pull in the rate. What can be the issue?

There are several reasons why you might see this message, and usually one of the following options resolves AFR display issues:

  1. Each calculation screen has the ability to modify the AFR rate based on their own needs. By default, the program will use the transfer date to match up the §7520 rate used for the screen. If you have already saved data, or been on a screen, it will default to the value that was in memory, before the AFR file transfer occurred. However, any time you change the transfer date, it will force the program to retrieve the §7520 rate that goes with that transfer date. So, if you change the transfer date by a month, it should pull in a §7520 rate. Then switch it back to the original month you wish to use, and it should pull in that §7520 rate.
  2. If the problem still occurs, it’s likely that your AFR.XML file is damaged. See FAQ “AFR Shows Current Table But Does Not Pull In Correct Rate“, solution #5
By |2021-01-19T17:25:24-05:00August 14th, 2020|Comments Off on AFR Shows Current Table But Does Not Pull In Correct Rate